Router instellen om plex te benaderen

Status
Niet open voor verdere reacties.

koezen1969

Nieuwe gebruiker
Lid geworden
15 mei 2015
Berichten
4
Hallo,

Ik heb een Draytek Vigor 2132 router (van de provider)
Ik heb plex server draaien op mijn pc.
Je kunt van buitenaf je plex server benaderen als je dat instelt.
Nu heb ik dat op de plex server ingesteld maar daar word aangegeven dat de server niet van buitenaf benaderd kan worden.
De oplossing van plex is het volgende;
"Not available outside your network

Enabling Remote Access to connect your Server with plex.tv works best with modern routers that support uPnP or NAT-PMP auto-configuration. These allow an application like Plex Media Server to automatically configure a port-forward on the router without you needing to do anything. Not all routers have these protocols, and some have implementations that don't work so well. If enabling Remote Access fails:

Find your router's user manual or on-line documentation
Check whether your router supports UPnP or NAT-PMP
If they do, you may need to switch the feature on in the router's software
If the services are enabled, try toggling them off and then back on again and try to connect the Server once more
If your computer has a firewall, proxy, ad-blocking software, anti-virus software, or similar installed, try temporarily disabling them and then attempt to connect the Server again

Sometimes, older routers offer UPnP support that may not work with new applications. If you cannot get the router to automatically configure the port-forward, you can seek help from the manufacturer or other forums. There may be upgraded firmware that fixes the issue.

If disabling the firewall allows successful publishing, you need to add the Plex Media Server to the firewall's allowed list. Consult the firewall's user manual."

Maar dit is mij veel te ingewikkeld. Vooral omdat ik de Draytek Router niet snap.
Eerder had ik een router van KPN en dat was veel begrijpelijker.

Is er iemand die mij hier doorheen kan loodsen zodat ik de router goed in kan stellen en plex ook van buitenshuis kan benaderen?

Alvast bedankt voor de moeite.
 
Kost samen gevat:

- er moet een poort open
- plex krijgt het niet voor elkaar met automatische aanvraag via UPNP
- handmatig poort open zetten

draytek handleiding

Je moet alleen dan nog de juiste port opzoeken om open te zetten.
 
Standaard is dat poort 32400.
Dat kan je eventueel wijzigen in de server instellingen van Plex.
 
Status
Niet open voor verdere reacties.
Steun Ons

Nieuwste berichten

Terug
Bovenaan Onderaan