Baystack 5510-48T Switch

Status
Niet open voor verdere reacties.

Jelleleeijen

Gebruiker
Lid geworden
16 dec 2013
Berichten
26
ik heb onlangs een netwerk-switch gekregen en wil deze programmeren maar:

IK KOM ER NIET IN ....

het is een Baystack 5510-48T
ik heb hem naar factory reset gedaan en zou het volgende ip moeten krijgen:


1 Press and hold the UI button for 3 seconds.
The unit will now be in configuration mode. The Status LED will
now change to a blinking green status.
2 Press the UI button 5 times.
The Base LED and the Up and Down LEDs will now be steady amber to indicate that the button press was recognized.
3 Press the UI button and hold in for 3 seconds to confirm the command.
The In-Use IP address will now be changed to 192.168.192.168. The color and status of the Status LED will turn to steady green once the command has been accepted. If the command is rejected, the Status LED turns amber blinking.
4 Initial IP configuration using the UI button is now complete. To continue with switch configuration, access the switch through the NNCLI, Web-based Management Interface, or Device M

ik koppel mijn laptop direct met Utp cat 6 kabel aan de switch en laat eerst via dhcp ip vinden komt heel ergens anders op uit dus handmatig ingevoerd 192.168.192.169
maar kom er dan nog niet in met het ip van de switch heeft iemand ervaring met deze switch programmeren?
 
Status
Niet open voor verdere reacties.

Nieuwste berichten

Terug
Bovenaan Onderaan