in plaats van dat ze nou een fatsoenlijke readme er neer zetten die ook begrijpbaar is voor beginners met linux
dit staat er over het instaleren
Linux* Base Driver for the Attansic(R) L2 Gigabit Ethernet Adapter
==========================================================================
Contents
========
- In This Release
- Building and Installation
- Command Line Parameters
- Additional Configurations
- Known Issues
- Support
In This Release
===============
This file describes the Linux* Base Driver for the Attansic(R) L2 Fast
Ethernet Adapter, version 1.0.x. This driver supports the 2.4.x and 2.6.x kernels.
This driver is only supported as a loadable module at this time. Attansic is not
supplying patches against the kernel source to allow for static linking of
the driver. For questions related to hardware requirements, refer to the
documentation supplied with your Attansic(R) adapter. All hardware
requirements listed apply to use with Linux.
Building and Installation
=========================
To build a binary RPM* package of this driver, run 'rpmbuild -tb
<filename.tar.gz>'. Replace <filename.tar.gz> with the specific filename of
the driver.
NOTE: For the build to work properly, the currently running kernel MUST match
the version and configuration of the installed kernel sources. If you
have just recompiled the kernel reboot the system now.
RPM functionality has only been tested in Red Hat distributions.
1. Move the base driver tar file to the directory of your choice. For example,
use /home/username/atl2 or /usr/local/src/atl2.
2. Untar/unzip archive:
tar zxf atl2-x.x.x.tar.gz
3. Change to the driver src directory:
cd atl2-x.x.x/src/
4. Compile the driver module:
make install
The binary will be installed as:
/lib/modules/<KERNEL VERSION>/kernel/drivers/net/atl2.[k]o
The install locations listed above are the default locations. They might
not be correct for certain Linux distributions. For more information,
see the ldistrib.txt file included in the driver tar.
5. Install the module:
insmod atl2 <parameter>=<value>
6. Assign an IP address to the interface by entering the following, where
x is the interface number:
ifconfig ethx <IP_address>
7. Verify that the interface works. Enter the following, where <IP_address>
is the IP address for another machine on the same subnet as the interface
that is being tested:
ping <IP_address>
---------------------------------------------------------------------------------------------------------------
dit staat er dus in t begin
To build a binary RPM* package of this driver, run 'rpmbuild -tb
<filename.tar.gz>'. Replace <filename.tar.gz> with the specific filename of
the driver.
ten eerste waar kan ik rpmbuild vinden"? nou ik nergens
ten tweede
1. Move the base driver tar file to the directory of your choice. For example,
use /home/username/atl2 or /usr/local/src/atl2.
welke er staan zoveel files? en in linux word het aan gegeven als een .7 file en niks met tar of iets dergeleiks?:S
