suse linux 10.0

[Jasmijn1947]

Hallo,
ik heb de instellatie goed doorlopen,maar wanneer ik nu wil opstarten in suse10.0 dan krijg ik een raar beeld te zien.Allerlij RGB kleuren, heel transperant , want je kunt er door heen zien en dan zie je suse linux met zijn toepassingen.Zels wanneer je met de muis over diverse pictogrammen gaat, de muis zelf zie je niet, kun je deze openen.
Mijn grafische kaart ,een ASUS EN6800/TD,is wel herkend.
Hoe kom ik wel direct in de grafische omgeving van SUSE????

 

[lamp]

Het probleem zit hem erin dat je grafische kaart niet goed word ondersteund door de open driver nv.
Je zal de officiele nvidia driver moeten installeren met you het enige probleem is dat je natuurlijk niet goed ziet wat je doet.

3. SUSE LINUX 10.0-IA32

It is recommended to use YOU (YaST Online Update) for (re)installation
of the nvidia driver. There are several reasons for this. First, it's
simple. Second, and this is the most important one, you won't need to
recompile the nvidia kernel module after a kernel update.

Inside YOU enable "Installable and Installed Patches" for "Show Patch
Category" and select "Download NVIDIA(r) Graphics Driver" from the
patches list (usually at the bottom of the list). Note, that you need
to mark it as "Update" (right mouse click) if you already installed it
before and the driver was uninstalled - for any reason. Proceed as
usual now. After YOU has finished restart your Xserver (i.e. logout
from your Xsession) and you're fine.

People who aren't afraid of recompiling the nvidia kernel module or
even reinstalling the nvidia driver each time the kernel has been
updated and want or need to use the latest and greatest nvidia driver
can use the following steps 1-3. The others should use the
instructions above using YOU and skip the steps below.

1) Kernel sources must be installed and configured. Usually this means
installing the 'kernel-source', 'make' and 'gcc' packages with YaST2.
Update it - if not already done - via YaST2 Online Update (YOU).

2) Use the nvidia installer for 1.0-8178.

sh NVIDIA-Linux-x86-1.0-8178-pkg1.run -q

3) Configure X.Org with

sax2 -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It's already
enabled, when the nvidia driver is running.

 

[lamp]

ubuntu lost dit iets mooier op. Hier volstaat even volgende regel in te voeren apt-get install nvidia-glx