Ik geef niets aan, computerfabrikanten hebben het zo aangegeven om het geheugen Dual channel te kunnen laten werken.
En een technische uitleg op het WW gaat ongeveer zo:
Dual-channel architecture DDR/DDR2 SDRAM describes a motherboard technology that effectively doubles data throughput from RAM to the memory controller.
Dual-channel-enabled memory controllers utilize two 64-bit data channels, resulting in a total bandwidth of 128-bits, to move data from RAM to the CPU.
In order to achieve this, two or more DDR/DDR2 SDRAM memory modules must be installed into matching banks, which are usually color coded on the motherboard. These separate channels allow each memory module access to the memory controller, increasing throughput bandwidth. It is not required that identical modules be used, but this is often recommended for best compatibility for dual channel operation. It is possible to use a single-sided module of 512 MiB and a double-sided module of 512 MiB in dual-channel configuration, but how fast and stable it is depends on the memory controller.
If the motherboard has two pairs of differently coloured DIMM sockets (the colours indicate which bank they belong to, bank 0 or bank 1), then one can place a matched pair of memory modules in bank 0, but a different-capacity pair of modules in bank 1, as long as they are of the same speed. Using this scheme, a pair of 1 GiB memory modules in bank 0 and a pair of matched 512 MiB modules in bank 1 would be acceptable for dual-channel operation.[1]
Modules rated at different speeds can be run in dual-channel mode, although the motherboard will then run all memory modules at the speed of the slowest module. Some motherboards, however, have compatibility issues with certain brands or models of modules when attempting to use them in dual-channel mode. For this reason, it is generally advised to use identical pairs of memory modules, which is why most memory manufacturers now sell "kits" of matched-pair DIMMs. Several motherboard manufacturers only support configurations where a "matched pair" of modules are used. A matching pair needs to match in:
* Capacity (e.g. 1024 MiB). Certain Intel chipsets support different capacity chips in what they call Flex Mode: the capacity that can be matched is run in dual-channel, while the remainder runs in single-channel.
* Speed (e.g. PC5300). If speed is not the same, the lower speed of the two modules will be used. Likewise, the higher latency of the two modules will be used.
* Number of chips and sides (e.g. 2 sides with 4 chips on each side).
Dual-channel architecture is a technology embraced by motherboard manufacturers and does not apply to memory modules. In other words, any matched pair of memory modules may support single- and dual-channel operation, provided the motherboard supports this architecture.
